Bracelet Holder
Due to the popularity of stacking bracelets, I’ve been collecting them left and right. And well, they are cluttering up my vanity. Therefore, I made myself and my daughter a couple of cute holders to keep them organized.
I love when something practical can be cute too!!
I love picking up old chairs on the side of the road and breaking them down. These are chair legs that I have cut down and sanded.
You will need scrap wood as well.
I cut two bases because as I said I made one for me and one for my daughter.
I sanded both bases then found the center of my base by marking an x on the underside.
I pre drilled a hole the the center.
This is the holder that will have to spindles for two stacks of bracelets. I drilled a screw up through the bottom.
You may want to pre drill a small notch in the spindle to make it easier. I then drilled into the spindle until it fit tightly on the base.
I did that twice.
This is the single one. I painted it and distressed it a bit. I’m keeping this one on my vanity.
My daughter has more bracelets than me so I gave her this one.
I hope you enjoyed this project 😊
Frequently asked questions
Have a question about this project?
How tall are the spindles ?