Supplies used for this wreath:
1 10 inch box wire wreath frame
Plastic canvas - can use pipe cleaners or zip ties to attach
Felt and zip ties to cover the back (optional but recommended)
I use 10 inch mesh for the outer leaves to reduce fraying so 1 roll of lavender in 10 inch.
1 21 inch roll purple
1 21 inch roll white
1 21 inch lavender for inner petals (or another 10 inch if you don't think you'd use the leftover, that's up to you)
1 21 inch roll of yellow
I cut the 21 inch mesh 10 inches long, then flip it sideways and cut it in half at the 10.5 inch mark. The half of a inch won't make a difference when folding the petals. Getting the 21 inch rolls will save a few dollars on the project.
Outer ring: not used
2nd ring in: 30 petals (purple/white) plus 30 leaves attached
3rd ring in: 25 petals (purple/white)
Center ring: 14 petals (lavender/white)
Center of frame: 13 petals on plastic grid (yellow/yellow)
The finished wreath will be approximately 26 inches in diameter.
This wreath is more time consuming and tedious than hard. Even I will usually try to break up making it into more than one sitting because it can get tiring. The end result is something very beautiful and different, but it is a lot of work! They take me about 8 hours to make.
The video in this post shows step by step how to make this wreath.