Use clear glue or Mod Podge to run around the inside of the bottle then pour out the excess. Pour the glitter in next and make sure the glitter hits all the glue.
Hello jean, you just need some glue that dries clear, like mod podge or diamond glaze, pour a small amount inside the bottle, turn and tilt and roll the bottle to spread the glue around, then if there is any excess glue (if any), just dump it out. Sprinkle enough glitter inside the bottle to coat it nicely, tilt, turn roll to spread it, once all the surface is covered, dump out excess glitter (if any) and let dry. Hope this helps you out!
I find the Mop & Glo works perfect. Put a little bit inside the ornament, swirl it around until the entire inside is coated. Pour out any of the extra and then put the glitter in! It will turn out beautiful!
Hi Jean, I've used watered-down mod podge mixed with lots of glitter (the fine glitter works best). Pour the mod podge/glitter mix inside the bottle and swirl it around so it coats evenly, turn the bottle upside down to dry.
I like to use Pledge floor finish to coat the glass. I pour glitter through a small funnel then shake the glitter around! The ornaments have held up for years... Hope this helps!
Any suggestions for removing RX lables from bottles? The lables circle the entire bottle. Would like to use them for spices, and cookie sprinkles I buy at a bulk fo...
See more
How can I preserve a 100 year old sticker on a glass pane. It is an old Pacific Telegraph and Telephone sticker on a door from a building that burned. The door and ...
See more
I purchased small 2oz. plastic flip top squeeze bottles to use for hand sanitizer that I plan to bling with rhinestones and give as small Christmas gifts.I was wonder...
See more
i want to place wreaths on my family members' gravestones at our Church cemetery, much like is done at Arlington National Cemetery on special occasions. I need ideas...
See more
I have been trying to drill a hole in the bottom of plastic ornaments to make a topariry but have been unsuccessful. Tried glue gun with no glue stick and a drill and...
See more
I want to make a board for my mom, she has Alzheimer's and is in LTC facility. She get a agitated every evening, I need a board to help keep her busy. ANY SUGGESTIONS
Here is the procedure using ornaments, should work well for your bottles:
https://www.youtube.com/watch?v=wD3UG35DUx4
HOW TO REVERSE GLITTER A BOTTLE SO IT DOESN’T SHED
https://www.gretasday.com/how-to-reverse-glitter-a-bottle-so-it-doesnt-shed/
Another for ornaments but should work for bottles
https://www.hometalk.com/diy/craft/ornaments/glitter-on-the-inside-ornaments-697200
"Glitter on the Inside" ornaments
Use clear glue or Mod Podge to run around the inside of the bottle then pour out the excess. Pour the glitter in next and make sure the glitter hits all the glue.
Paint the inside of the bottle with ModgePodge, then sprinkle in the glitter and swirl it around till covered.
Hello jean, you just need some glue that dries clear, like mod podge or diamond glaze, pour a small amount inside the bottle, turn and tilt and roll the bottle to spread the glue around, then if there is any excess glue (if any), just dump it out. Sprinkle enough glitter inside the bottle to coat it nicely, tilt, turn roll to spread it, once all the surface is covered, dump out excess glitter (if any) and let dry. Hope this helps you out!
here is info Jean
https://www.pinterest.com/pin/176555247870621471/
Some people coat the inside with Mop & Glo floor wax first.
I find the Mop & Glo works perfect. Put a little bit inside the ornament, swirl it around until the entire inside is coated. Pour out any of the extra and then put the glitter in! It will turn out beautiful!
I have seen mop & glo and baby oil used. You put a few drops in, roll around and drain excess. Then add glitter and roll around.
Hi Jean, I've used watered-down mod podge mixed with lots of glitter (the fine glitter works best). Pour the mod podge/glitter mix inside the bottle and swirl it around so it coats evenly, turn the bottle upside down to dry.
Use glitter glue instead of just glitter
You could spray hair spray in the bottle then add glitter
I like to use Pledge floor finish to coat the glass. I pour glitter through a small funnel then shake the glitter around! The ornaments have held up for years... Hope this helps!
I’ve seen baby oil used inside ornaments. Also mop and glo. Make sure to remove excess first then add glitter.
Thank you all so much I am going to have lots of fun trying out different ones , merry Christmas