Using a 3/16 inch drill bit, drill through the first rivet head on the locker's metal frame. Take great care not to drill into the metal locker itself. You will need to repeat this process until all the rivets are removed.
I removed the old casters from the legs, but want to replace them altogether with taller legs (without casters). I can't figure out how to get the legs off. Any advic...
See more
I recently acquired a beautiful old barley twist desk which there was no way around refinishing. I had a hard enough time successfully removing most the old varnish f...
See more
H Holly. I think you'll have to grind of the head of the rivet and then hammer out the rivet with a punch.
Hopefully this article will help https://lockup.com/wp-content/themes/lockup/documents-guides/special-instructions/Lockup_Maintenance.pdf
Hi Holly! Here's a good instructional:
https://www.doityourself.com/stry/how-to-remove-a-pop-rivet
Hi Holly, hope this helps you out.
Using a 3/16 inch drill bit, drill through the first rivet head on the locker's metal frame. Take great care not to drill into the metal locker itself. You will need to repeat this process until all the rivets are removed.
You have to either cut the to of the Rivet off or drill it out.