From here
Is there an easy way to move this light switch to inside the closet?




My father put a closet light switch on the outside of the closet. Is it possible to just open up the wall on the other side, turn it around and close up the wall???


Turned around directly on the other side
Related Discussions
How to get rid of mice?

We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?

I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to trap fruit flies?

Does anyone know how to get rid of fruit flies with a homemade trap?
How to remove popcorn ceiling with vacuum?

Is there a way to use a vacuum to remove a popcorn ceiling?
How to fix a crack in a door frame?

How to fix a door frame with a split in it?
How do I kill the power from my main breaker?

I have a home built in 2006, the main panel does not seem to have a main breaker...? See attached pic of the main panel. It's a Siemens G3040 200 amp panel. Outs... See more
Any Ideas for this corner with the wood stove pipe?

I am unclear as to what to do with this part of my house, "The Breakfast Nook".
Here are some easy steps: https://www.hunker.com/13402594/how-to-move-a-light-switch
Yes.
yes make sure all electric is off on main circuit breaker box before starting any electric work. get your self a stud finder before cutting into wall to look for/find stud to move switch box too. cutting new hole https://www.youtube.com/results?search_query=diy+cut+hole+in+drywall+for+outlet+ move the switch box https://www.youtube.com/results?search_query=diy+moving+light+switch+to+other+side+of+wall patching old hole https://www.youtube.com/results?search_query=diy+patching+drywall
Yes. You would just have to rewire it and reattach the box it to the stud and then have to cover the hole up with drywall. You can get a drywall kit at the hardware store.
Yes you can, probably without even disconnecting the wire from the box. The easy way to patch the square hole is to cut a bit of drywall at least two inches larger than the hole. Trim off the excess drywall from the paper and then insert into the hole. It should fit snugly and then patch with the drywall compound. So much easier to do it this way as the paper overhang will stick to the other drywall and will make it easier to repair.
Yes, if you've already got good wiring skills. Otherwise I'd highly recommend an electrician as bad wiring can burn your house down.