PVC and Leather Hanging Planter
by
Amanda C, Hometalk Team
(IC: paid contributor)
2 Materials
$10
45 Minutes
Easy
Add a touch of charm to any window with this PVC cap and leather strap planter. This tiny little number is perfect for a small succulent or air plant.
MATERIALS:
STEP 1: Sand down any words or rough spots on the PVC cap.
STEP 2: Drill a hole toward the open edge of the PVC cap on one side. Mark a spot on the other side of the PVC cap directly across from the hole you just made and drill another hole.
STEP 3: Take your ruler and mark a " wide strip and make it as long as you wish. Using your rotary cutter cut the leather strap out. (If you have purchased leather trim instead simply cut the length that you wish your hanger to be). Mark a 'V' on each end of the strip and cut off each corner leaving a point at each end.
STEP 4: Place the tip of each leather strip through the holes on each side of the PVC cap. Thread the strip through the hole long enough to allow for them to reconnect past the edge of the PVC.
STEP 5: Using your knife / awl / or eyelet pliers pierce holes through the leather strap just above the PVC edge.
STEP 6: Place a short bolt through the holes on each side of the PVC and screw into a nut on the other side.
STEP 7: Now you're ready to plant!
Enjoyed the project?
Suggested materials:
- PVC End Cap (Home Depot)
- Leather (Fabric Store)
Published May 15th, 2016 10:15 AM
Comments
Join the conversation
2 of 59 comments
-
Theresa. ferren on Jun 13, 2017
First time planter here what kind of plant to use besides cactus in a planter thst smallest
-
-
Doreen Kennedy on Jun 07, 2021
Perfectly adorable
-
Frequently asked questions
Have a question about this project?
This is so cute..Question….what kind of drill bit did you use to keep pot from cracking???.I want to make one.