Engrave Stainless Steel Tray for Mother's Day Gift
by
Janice Anderssen
(IC: blogger)
use a dremel multitool and grinding stone to engrave on stainless steel tray for mother's day gift
Dremel asked me to try out the new Dremel Fortiflex and do a project for Mother's Day to show how easy it is to use this tool - due to be launched soon. I decided to engrave a stainless steel tray - cheap at the local discount store!
An inexpensive stainless steel tray is engraved as a special gift for Mother's Day.
Although I used the Dremel Fortiflex for this project, you could use any Dremel MultiTool to engrave on stainless steel, as long as you use a silicon carbide grinding accessory (included when you buy most tools).
1. Use the china marker to draw the starting point for your design onto the tray. You can only draw a small section at a time as the marker wipes off easily.
2. Now you can apply pressure on the foot pedal and start engraving on the tray, working slowly over the drawn outline. Continue to draw and engrave until you complete the design around the entire tray.
3. For the wording I used my PC and printer to print out a design that would fit nicely in the centre of the tray. The wording was cut out with a sharp craft knife on my Olfa cutting mat. The wording was taped down using masking tape.
4. Use the grinding accessory to outline the letters - you can fill in later on. You will find that the paper template helps to prevent mistakes and you can turn the tray around as you work to make drawing lines easier.
5. After you have outlined all the letters, remove the tape and fill in the centre of the outlined letters.
The completed lettering after filling in. Now all you have to do is polish with a soft cloth and buff to a shine!
Enjoyed the project?
Want more details about this and other DIY projects? Check out my blog post!
Published April 30th, 2015 11:28 AM
Comments
Join the conversation
2 of 14 comments
-
Rose Broadway on Dec 24, 2017
Another great way to give a special gift! Thank you!
-
-
Frequently asked questions
Have a question about this project?
Could this be done on glass?
Hello, could you tell me where you obtained the little duckies?