Garden Pegboard
![Kelsey | A Dabbled Dwelling](https://cdn-fastly.hometalk.com/media/profile/2020/04/22/48896465_2.jpg?size=91x91)
How cute is this little utility station! I had seen these before but never outside and thought it would be a great addition to my new patio. This whole project is basically drilling holes!
It's hard to see but I measured and penciled a grid onto my 2x4 piece of plywood. The birch usually has a more appealing grain. Each mark is 2 inches from the edge and 3 inches apart.
Using a 1 inch bit, drill your holes into the board.
Its always a good idea to seal a project and since this is going outside I did 4 coats of Polycrylic
I cut my dowel rod into peices to make my pegs. The length will depend on use. Some were long for shelves and some were short for hooks.
I also added these cute wooden hooks I got on Amazon
I used a masonry bit to drill into my brick and hang a french cleat but there are many ways you could choose to hang.
I accessorized and made shelves using scrap 1x4 pieces of wood.
What do you think?
Enjoyed the project?
Resources for this project:
See all materialsComments
Join the conversation
-
KenH on Jan 02, 2021
Looks great! Also, please use more protective gear when working with tools.
- See 3 previous
-
Kelsey | A Dabbled Dwelling on Jan 24, 2021
Its just a drill haha
-
Kym Dawson-Boulanger on Jan 24, 2021
I said the same. Gives women a bad example
-
-
Edy Watkins on Dec 29, 2022
I really like it for those sunnier climates that don't get a lot of humidity or rain. Here in the PNW, it would have to go indoors. Love the French cleat. Good job!
-
Frequently asked questions
Have a question about this project?
How did u cut the dowel to make hooks.
Have you put a backing to the peg board to prevent the pegs (Dowell ) going in too much
Why do you have flip-flops on and no safety glasses?