Chic Wooden DIY Toothbrush Holders

Here's how to make these toothbrush holders.

Materials:

7.5cm x 1.5cm (3″ x 0.6″) oak discs*

24mm (0.94″) small wooden rings*

small hand saw

sand paper

wood glue

wood protector/sealer (ideally a food grade one)

3M command picture hanging strips 

*you can buy the wooden rings and similar oak discs on etsy

1. Start by cutting the wooden rings with your hand saw. My toothbrushes are pretty slim so I cut them in half. However check the thickness of your toothbrush – you may need to cut off a third only.

2. Very lightly sand down the edges of the wooden ring so that there’s no splinters or uneven bits. But you don't want it too smooth.

3. Mark the centre of your oaks disc and glue the piece of wooden ring on with the wood glue. Wipe off excess glue and leave to dry.

4. Follow the instructions on your wood protector to seal the wood and protect it from moisture.

5. Attach the picture hanging strips as per the instructions and attach to your bathroom wall.

Note: You can screw these in to the wall but I used picture hanging strips as I put mine on a tiled wall and I really didn’t want to drill in to my tiles. Also if you screw them in, the screw will be visible which isn’t the look I wanted.