Easy Metallic Tree Ornaments
I love making Christmas tree ornaments as they’re so easy to make. I brought some special chameleon powders from the brand “let’s resin” that I wanted to try out and here’s the result.
Before
These are the plain Christmas ornament moulds that I brought from Amazon. I love these moulds, they’re so easy to fill and I’ve had them a while.
I brought these chameleon powders from the company “let’s resin” I’ve herd a lot of good things about them and can’t wait to try them out.
With these powders you have to brush it all over inside the mould. Make sure you cover all areas.
Now it’s time to mix up your resin.
You want to mix up 100ml of resin and hardener so 50ml of each. Depending on if your resin is a 1:1 ratio or completely different. You will have to check your resin brand as this is important.
Time to pour… you want to pour slowly so you don’t create any bubbles, if you do just use a heat gun to pop them.
After all the moulds had been filled, leave this for 24 hours to cure.
To hang the ornaments on the tree I threaded a bit of red ribbon through the holes and tied into a knot.
After
Now these are finally ready to give as gifts or hand on your tree. I’m really pleased with the outcome using the chameleon powders and would really recommend trying them out.
DIY Christmas Decorations
Enjoyed the project?
Suggested materials:
- Resin and Hardener (Amazon)
- Moulds (Amazon)
- Chameleon Powders (Let’s Resin brand)
Frequently asked questions
Have a question about this project?