DIY Entry Way Coat Rack
Simple DIY entry way coat rack with mail organizer and floating shelf.
Start by cutting your 1x10" at a length of 32", your 1x4" at a length of 19.5", two 1x2" pieces at 9", and three 1x2" pieces at 10.5". Sand your wood once it's all cut to length.
Next, glue and nail your 1x2" pieces together. Use one of your 10.5" pieces as the bottom and your two 9" pieces as the vertical sides. Your two remaining 10.5" pieces will be placed horizontally across your two 9" vertical pieces. I spaced these 10.5" pieces 1" from the bottom and 1" from each other to create two even gaps. This will be your "mail catcher".
Now for your floating shelf....
Measure 1" from the top of your 1x10" and mark your measurement. Add wood glue to one of the long edges of your 1x4" and place it at your 1" measurement, leaving a one inch gap between the top of your 1x10" and your 1x4". Nail your 1x4" to your 1x10" from the back side.
Stain or paint your wood and let dry over night. Once dry, add polyurethane for a shinier finish.
Once dry, align your mail catcher flush with the bottom of your 1x10" and 1" from the side of your 1x10". Apply wood glue to the back of your mail catcher and nail it to your 1x10" from the back side.
Next, take your coat hooks and align them as you please. I ended up clamping a piece of 1x2" scrap wood flush with the bottom of my 1x10" to create an even 1" gap from the bottom of my 1x10" and each coat hook. Place the coat hooks at an equal distance apart and screw them down. I placed mine 2 3/4" apart.
On the back of your coat rack, take two key hole hangers, make sure they are level, and screw them in. For my coat rack, I placed them 3" down from the top of the 1x10", and 7" from each side of the 1x10".
Use a drill bit that will fit inside your keyhole hanger to carve out the wood so you can hang your coat rack. Make sure not to drill all the way through to the other side! A 1/4" should be fine.
Your coat rack should now be ready to hang!