Shape filler piece of wood to insert in hole, cover with epoxy, and paint over with a wood stain.
Cut off the rotted sections and brick moulding, and apply a replacement piece with shims.
Place a wet towel on top of the veneer, let it soak into the wood, and scrap off easily.
Locate the chipped off piece of the baseboard, use Gorilla Wood Glue, and put tape over the chip to keep it in place till dry.
Apply the oil onto the wood in small amount and rub into going with the grain.
Take a putty knife, after filling the gouge with filler, to shape the filler to the size of the gouge and let dry.
Sand off previous paint, run torch fuel up wood, and put flame on the wood long enough to burn.
Begin filling in the indentations, let dry, and brush over with paint of choice.
Apply moderate amount of Spackle, let dry, then paint over the wood.
Use Band-It Veneer Edging, painter’s tape, and activate the heat on the tape by using foil on a iron.
Mix the two parts of bondo together, remove loosened veneers, and apply.
Use a stripping gel, sand down by hand, then makeover as desired.
Mix equal parts mayonnaise, lemon juice, and olive oil to rub into dry wood to moisturize it.
Remove decaying wood, vacuum the area, and seal with Elmer’s Structural Wood Repair.
Remove dog chew marks on table legs by sanding down and JB Kwikwood to sculpt and repait the leg.
Adding lemon juice and vinegar together is a powerful cleaning agent for wood floors.
Take ¾ cup of Canola oil and mix with ¼ cup vinegar, and wipe the wood.
Coat windowsill with Epox and smear, then coat with a primer.
Rub petroleum onto a water spot, let soak in, then wipe off the surface.
Sand down the damage veneer, stain the wood, and apply moulding.
Buy a wood shelf liner with contact paper, and apply onto the surface.
Take a screw and dig into the wood and drill out the hole with a dowel.
Insert wood toothpicks and fill with Elmer’s Wood Glue Max.
Apply Mineral Oil onto the residue and scrub off the tape grime.
Bust open a walnut and rub it over the scratch to remove it, then cover up with a touch-up marker.
Eliminate damage by applying a restoring stain and wipe off after 3 minutes.
Clean the surface of the wood and use a rag to protect the wood.
Use Stickwood by simply peeling and sticking onto the surface.
Use Loctite Glue over the surface, allow to dry, and cover with paint.
Apply coconut oil over wood to create a wood grain with matte shine.