10K Views
Beautiful String Dispenser From a Soda Bottle
![Nancy at Craft Your Happiness](https://cdn-fastly.hometalk.com/media/profile/2020/04/12/1549455_7.jpg?size=91x91)
by
Nancy at Craft Your Happiness
(IC: blogger)
10 Minutes
Easy
You can make a very beautiful string dispenser in minutes! Use any size bottle you wish. I used a plastic 16 oz coke bottle because I liked the curved design.
SUPPLIES
Cut a door type opening large enough in the back of the bottle to slip your ball of string into.
Drill a small hole into the lid which your string will feed through.
Decorate the outside with whatever you want. I use wide ribbon and an artificial flower. I then attached smaller ribbon to it so I could "tie" the decoration around it and then easily remove it to change the string later. MORE DETAILS AND PHOTOS ON POST BELOW.
Enjoyed the project?
![Nancy at Craft Your Happiness](https://cdn-fastly.hometalk.com/media/profile/2020/04/12/1549455_7.jpg?size=91x91)
Want more details about this and other DIY projects? Check out my blog post!
Published June 21st, 2015 11:35 AM
Comments
Join the conversation
2 of 5 comments
Frequently asked questions
Have a question about this project?