DIY Gold Napkin Rings

3 Materials
10 Minutes

This project is a inexpensive way to fancy up your place settings on a budget!

Materials Needed

20 Gauge Copper Wire, Baking Roller and Wire Cutters.

You can get a little thicker wire if you wish.

Step 1

You are going to start by wrapping the wire around the rolling pin.

Make sure you leave about a inch to a inch and a half at the end that is not being wrapped.

Step 2

You are going to wrap the wire around the rolling pin 10 times.

Then using the wire cutters, cut the wire leaving a inch to a inch and a half left over at the end.

Step 3

With the extra ends, you want to twist once.

Step 4

Now carefully remove the wire. Hold the wire together tight do to the fact we have not tide the wire together. If not then it will all come apart.

Step 5

With the ends wrap the extra wire around the ring.

Step 5 Continue

Make sure you wrap each side of the extra wire going the opposite way. For example, the right wire, push it forward around the ring. The left wire, pull it back around the ring.

Step 5 Continue

Continue to wrap the ends till you have just a little bit left.

Step 6

Now with what little of the wire is left twist the ends.

Step 7

Then twist the reminder around the ring leaving nothing else sticking up.

Step 7

All Done!

Lastly separate the wire.

Thank you for reading! I hope you enjoyed this DIY Home Decor

More Thanksgiving Table Decor Ideas

Explore additional DIY table decoration inspiration in our Thanksgiving table decor guide.

Resources for this project:
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Frequently asked questions
Have a question about this project?
  1 question
  • Peggy Peggy on Apr 22, 2020

    Where is gold ? In the beginning it says gold. It's pretty as copper!

Join the conversation
2 of 6 comments