How To Finger Crochet A Chunky Roving Yarn Wreath

2 Materials
15 Minutes

Learning how to finger crochet a chunky roving yarn wreath is super easy and the finished look is so soft and pretty. It takes just a bit of practice then you’ll be finger crocheting a wreath in no time! I also have another nice yarn for finger crocheting linked below.

You can read more about the best yarns to use at

The Right Wreath Frame for Finger Crocheting A Wreath

The type of wreath frame will determine the overall look of your wreath. The loop stitches on the top will look the same, but the wider the wreath frame, the longer the straight pieces will be.

I like to use a wire wreath frame or a styrofoam wreath frame when making mine. You’ll have to choose which look works best for you.

How To Finger Crochet A Chunky Roving Yarn Wreath Step-By-Step

Before you get started, I recommend cutting off about a 3-foot section of yarn to practice with. Roving yarn untwists and gets super soft and fluffy. If you have to start over too many times it will lose its shape and be unusable. I taught myself with a shorter piece until I got the hang of it.

You’ll start by making a slipknot and leave about a six-inch tail on the end to use for tying off when you’re done crocheting with your fingers. You want the loop just barely big enough to fit your thumb and two fingertips through. I’ll explain this as best as I can. I’m right-handed so you may need to reverse this if you’re left-handed.

Hold your slipknot on the right and lay your ball of yarn on the left. Unwind enough yarn to work with and pay attention as you go and unwind more so it doesn’t tighten or your stitches will get too tight.

Reach through the center of the wreath and grab your working yarn and pull it up through the center.

Our Goldendoodle apparently left her paw prints in my foam board. Oh, June….

Gently pull the working yarn up and behind your two fingers and then over the top of the same two fingers.

Let go of the working yarn but keep your right hand with the yarn on it down close to the wreath frame.

Reach over the TOP of the wreath, pull up the working yarn up and over the TOP of the wreath frame, and pull it through both loops. You just did your first stitch! It doesn’t look like much yet but it will. Don’t let your stitches get too big. Sometimes you have to pull back on the working yarn to keep things a little tighter. Not too tight, but also not super floppy. The loop on the right ends up being a little longer than the loop on the left.

Now repeat this process. The stitches will work in a counter-clockwise direction around the wreath, so the next stitch will be on the left of the first. Here’s a quick recap:

  • reach through the CENTER of the wreath
  • pull up behind the two fingers then over the top of them
  • let go of the working yarn and pick it back up by reaching over the top of the wreath
  • pull the working working yarn up and over the top of the wreath and through the two loops
  • remember to check to see if your working yarn is unwound enough after a few stitches so it doesn’t tighten

Arranging The Stitches

After you get five or six stitches, bunch them up a bit so you can’t see your wreath frame. Shape it a bit then repeat the process and continue to bunch until you get all the way around the wreath. How much yarn you need when finger crocheting wreaths depends on the size of the wreath frame.

Tying Off The Back

When you get to the end cut your working yarn off but leave another 6-inch tail. Take the first tail you started with at the knot end and slip it through the last loop you made on the wreath. Arrange the two tails towards the back of the wreath without pulling too tight and tie a knot in the back. You can trim those off but leave a couple of inches and weave them back through on the backside of the wreath to hide them.

You can hang your crocheted wreath with a ribbon or hide a wire on the back for hanging. These cute DIY wreaths look so pretty. As another option, you can twist the stitches to the outer edge. I’ve seen that done and it’s a pretty method as well.



Resources for this project:
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Denise - Hootshack
Want more details about this and other DIY projects? Check out my blog post!
Frequently asked questions
Have a question about this project?
Join the conversation
 1 comment
  • Tara Eason Tara Eason on Jun 26, 2022

    I do believe it would have been a lot easier for some of us to just seen a video on this but I will say this about it. Very beautiful in the endand I really would have loved to made it. Thanks for showing us