Table Leg Candle Holders

STEP 1: Remove screw

Because I didn’t want to risk drilling into the Terra Cotta saucers and cracking them, I decided to remove the screws at the top ends of the table legs and use another method to attach the legs to the saucers. I simply used a pair of pliers to twist the screws out of the table legs.

STEP 2: Adhere saucers to legs

After the screws were removed, I mixed the epoxy according to the directions on the package and applied it to the table legs.

Make sure not to get this stuff on your hands! I got a teeny tiny bit on my hand and it did not feel good!

I flipped three of the saucers upside down and put the epoxy coated table leg end down on the saucer....

...then, I did the same for the top end of the table leg and attached another saucer (bottom side down) to it—this is where the candles will sit. Even though the epoxy package says it sets in 5 minutes, I let my candle holders sit for about an hour to ensure that they were set.

The cool thing about this particular epoxy applicator is that you can use the little black piece that came attached to it and put it back on the tip so it can be used again for another project.

STEP 3: Paint candle holders

Once the candle holders were assembled and completely dry, I painted them so that each of them looked like one holder from top to bottom. I chose a neutral, vintage white. Feel free to show your personality with these!

I ended up doing two coats of paint on these for a rich, solid finish.

I’m obsessed with these table leg candle holders!!! I want to make them for all over my house and as gifts! Because these will be in our kitchen and out of reach of tiny hands, I chose to use real candles; however, if you’re want to err on the side of caution, you can always use battery powered candles. Another step that you could add once the paint is dry on these candle holders is felt on the bottom if you’re afraid your holders may scratch whatever surface you plan to sit them on.