Rolling Work Bench With Storage
by
Nicole
(IC: homeowner)
5 Materials
$75
3 Hours
Medium
I have a new mitre saw and needed a place to mount it. I also wanted it to be mobile so I could move it where I need it.
- Started by gathering all the necessary lumber (details at end of post!). I wanted 3 shelves and the top shelf I wanted something that resembles butcher block. Found a great panel piece at Lowe's that seemed the perfect size.
- The middle and bottom shelf didn't have to be fancy so I grabbed some precut pieces of plywood that were exactly the same size as the top panel.
- The legs are standard 2x4s cut to 36"
Using 2" L-brackets I attached the 2x4s to make a corner. I made 4 of these, one for each corner.
I used a 1" thick piece of scrap lumber to raise my bottom shelf up about 1" off the floor. I situated the corner pieces around the bottom shelf and secured through each end with 2" wood screws.
I used scrap pieces of lumber again to hold up the middle shelf around 18" from the top. I secured these in around each side with wood screws.
I attached casters while I had the unit upside down. I did this before I attached the top shelf to ensure I didn't scuff up the top.
Since I didn't have a second person to hold the top shelf in place while I secured inside each corner, I decided to use extra pieces of lumber I had lying around in order to give me some extra length to attach the top.
I secured the top to the extra panels I just installed in prior step
I added a 1x2" apron around each side.
It's not the prettiest thing I've ever made but it certainly does the job!
I'll be mounting my mitre saw to the top and adding a few S-hooks in order to have some hanging storage.
Enjoyed the project?
Suggested materials:
- Large panels for shelves (3); 48"x24" (Lowe's)
- 2x4x3' (8) & 1x2x4' (1) (Lowe's)
- 2" L-brackets (8) (Lowe's)
- Wood screws (lots!) (Already had)
- Casters (4) (Lowe's)
Published August 7th, 2017 9:07 PM
Comments
Join the conversation
2 of 6 comments
Frequently asked questions
Have a question about this project?